Large flange eliminates the sharp edges and step of conventional bushings. 1911 fits Govt.; Comm. fits Commander; Off. fits Officers ACP. Mfg: Egw SPECS: Machined, Blue, matte finish or stainless steel (SS). Govt. has .575" (14.6mm) I.D. and .702" (17.8mm)...
Less time-consuming fitting because the proper lockup angle is pre-machined right into the bushing. Pre-Fit requires only minor fitting for installation onto Colt factory barrels. Gunsmith Fit requires fitting of both dimensions. Mfg: Egw SPECS: 416 stainless...
Set of six, stress-proof, hardened chrome-moly steel barrel links helps correct most barrel-to-frame fit and feeding problems on 1911 autos. Includes the following link sizes (measured center-to-center from barrel link pin hole to slide stop hole): factory...
Self-piloted Reamer cuts the spring guide tunnel to the proper depth and diameter. Mfg: Egw SPECS: Tool Steel (TS) or Carbide (Carb.) blades. 8" (20cm) long, 7/16" (11.1mm) dia. shank.
Reverse Plugs fully machined from lead-free steel. Extra- strong, integral collar. Mfg: Egw SPECS: Reverse Plugs - 1018 machined steel. 1.70" (4.3cm) long 1/2" (12.7mm) dia. body, .530" (13.5mm) dia. collar. All reverse plugs will require fitting....
Ultra-hard sear gives a clean-breaking, light-feeling trigger pull with little or no time-consuming stoning-can be installed straight out of the package in many cases. Precision CNC-machined from tool steel barstock, then ground for precise geometry to...
Hardened, competition-grade ejector is left long at both ends so you can fit for different calibers and slide contours. Additional metal at the rear can be ground off flush with the slide after barrel fitting so there's no unsightly gap between the ejector...
Machined, hardened steel insert lets you convert alloy frame pistols to use hollow point ammunition without feeding problems or damage to frame. Also the perfect solution for repairing a frame that's been battered by hollow points or boogered up by an...
Tough, durable firing pins are precision machined from extra-hard stainless steel to fit in the slide with .001" clearance to help eliminate "primer flow'' with hot loads. Helps prevent jams and misfires caused by the primer backing out. Available in...
Eliminates red dot bounce and recoil. Forward canted ports diminish powder fouling on scope. Available with integral cone or threaded for use with Hybrid Compensated Barrel Systems. Mfg: Egw SPECS: Steel, in-the-white. Hybrid-Style - 2.3" (5.8cm) long....