2XTM 9mm CONVERSION Magazine opening has been cut for the dimensions on the 2XTM conversion instructions. Receiver rails will need to be shortened to fit the magazine adapter. 1/8" alignment pin holes are pre-drilled.Precision-cut, ready-to-bend steel...
Newly-manufactured parts eliminate the struggle of trying to build a reliable gun with worn out, used Eastern Bloc parts. These high quality rivets, pins and reinforcement plates are just what you need to successfully complete your AK Rifle build. Beefed...
Newly-manufactured parts eliminate the struggle of trying to build a reliable gun with worn out, used Eastern Bloc parts. These high quality rivets, pins and reinforcement plates are just what you need to successfully complete your AK Rifle build. Correctly...
Newly-manufactured parts eliminate the struggle of trying to build a reliable gun with worn out, used Eastern Bloc parts. These high quality rivets, pins and reinforcement plates are just what you need to successfully complete your AK Rifle build. Every...
STANDARD AK-47 7.62x39 For building a standard, fixed-stock AK-47/AKM in 7.62x39. Use with the Romanian and most common variant kits. 1/8" alignment pin holes are pre-drilled. Available with or without front and rear trunnion holes pre-punched.Precision-cut,...
Newly-manufactured parts eliminate the struggle of trying to build a reliable gun with worn out, used Eastern Bloc parts. These high quality rivets, pins and reinforcement plates are just what you need to successfully complete your AK Rifle build. Extended...
AK-47 Polish Underfolder For building a Polish AK-47 in 7.62x39mm with AN underfolding stock. Do not use with Yugo M70/M92, Hungarian AMMS, or Romanian underfolder rear trunnion. 1/8" alignment pin holes are pre-drilled.Precision-cut, ready-to-bend steel...
Direct replacement for original factory part. Crisp edges engage all types of magazines for reliable magazine retention. Mfg: Ak Builder SPECS: Stamped steel, black oxide finish. .200" (5.1mm) diameter hole. Fits all AK-47 and AK-74.
Replaces worn or weak magazine catch springs. Always a good policy to replace the spring whenever you replace or work on the mag catch itself. Mfg: Ak Builder SPECS: Heat-treated spring steel wire. Fits all AK-47 and AK-74.
Newly manufactured triggerguard without the magazine catch pin hole. Allows individual fitting of the magazine catch. Corrects the dimension stacking problem on out-of-spec receivers that causes loose fitting magazines that rattle and won't feed properly....